First, the board is processed into a thick and thin sheet, the surface should be smooth, then the sawing board is spliced, the general white latex is used for splicing, and then fixed, and dried in one day.

Second, you can draw some beautiful patterns on the wooden box. If you have special requirements, you should also specialize in pattern making, soak the prepared pattern in water for a few seconds, take it out and stick it directly on the wooden box, then use the scraper to hang the water inside, and leave it. After less than 10 hours, gently peel off the upper plastic film and cover it with a top coat.

Third, the treated wood board is first polished, then the putty is applied, and after a day of polishing, if it is not necessary to re-grind and then sand, it must be smooth because it depends on the smooth and smooth paint. Then it is the primer, after a day of grinding, you can use water sandpaper, then paint and then grind 600 or more, until the hand feels smooth, then brush the topcoat, thin and even, after a week is completed.